郭英姿 谢伟丽 王鹏义 张瀚方 高华东.纳米SiO2对poss复合树脂弯曲和抗压强度的影响[J].,2014,14(31):6050-6052 |
纳米SiO2对poss复合树脂弯曲和抗压强度的影响 |
Impact of Nano-silica Upon Flexural Strength and Compessive Strengthof Poss Composite Resin |
|
DOI: |
中文关键词: 纳米SiO2 poss复合树脂 弯曲强度 抗压强度 |
英文关键词: Nano-silica Poss composite resin Flexural strength Compressive strength |
基金项目: |
|
摘要点击次数: 943 |
全文下载次数: 961 |
中文摘要: |
目的:观察纳米SiO2填料对纳米复合树脂poss 的弯曲强度和抗压强度的影响,探究纳米SiO2的最佳添加比。方法:将经过
硅烷偶联化的纳米SiO2颗粒加入poss 复合树脂中,合成SiO2质量分数分别为0.5%,1%,1.5%和2%的SiO2/poss 复合树脂,分别
为BCDE 四组,纯poss组为A 组(对照组)。每组试件固定于万能材料测试机上,以1.0mm/min 的速度垂直加压直至试样破坏,采
用SPSS16.0 软件对结果做单因素方差分析。结果:弯曲强度测试结果:C 组最高,与其他四组均有统计学差异(P<0.05);A、B、D
三组无显著性差异,与E 组差异明显(P<0.05)。抗压强度测试结果:D 组最高,与其他四组均有统计学差异(P<0.05);B 组和E 组
与A 组差异显著(P<0.05),与C 组无显著差异。结论:纳米SiO2在一定范围内能够提高poss复合树脂的弯曲强度和抗压强度。 |
英文摘要: |
Objective:To observe the effects of nano-silica upon flexural strength and compressive strength of poss composite
resin.Methods:After measured 0.5wt%, 1.0wt%, 1.5wt%, 2.0wt% by the electronic balance, nano SiO2 particles were added into poss
composite resin respectively. Flexural strength and compressive strength of each material were determined by Zwick/Z010 universal
testing machine, which were pressed by 1 mm/min until fracture occurred. The data were analyzed by ANOVA with the use of SPSS16.
0 software.Results:The data of flexural strength revealed that Group C exhibited higher flexural strength than the other four groups.
There was no statistical difference among Group A, B and D, but important diferences could be seen between Group E and any of the
above three groups. Result of compressive strength testing: The compressive strength of Group D is the highest. There was statistical
difference between Group A and Group B, the same difference could be seen between group A and Group E. There was no significant
difference among Group B, C and E.Conclusion:Approriate proportion of nano-silica could enhance the flexural strength and
compressive strength of poss composite resin. |
查看全文
查看/发表评论 下载PDF阅读器 |
关闭 |